Vancomm Part # LPMK-D-C

Sold as a complete kit

Threaded Rods 24″ x 62″ Steel Grating and Grating Clips Included

Proposed bts platform to be constructed so as to match the existing platform frames. Frame channels¬† and angles are to be the same size, thickness and Steel grade (a36) as the existing platform frames. Legs are to be the same steel members and length as the existing platforms. Attach proposed channels to existing platforms using typical l5x3 1/2×1/4.

2. Temporarily lift existing platforms, remove (cut off) Existing leg base plates, install proposed c10 to run
The entire length of the platforms. Install rubber Mat (site pro p/n mat18) underneath full length of
C10 to protect rooftop surface.

3. Install c8 channel section underneath leg locations To provide support for existing base plates. C8 to be
Installed upside down, giving a flat surface upon Which base plate will rest.

4. Move existing platform utilizing existing un-used Bolt holes, 7″ to the right. Construct 16″ wide
Platform extension on the left of existing platform. Platform extension to have one through bolt
Installed through wall, and be connected to Existing platform utilizing a325 bolts Рminimum (3).

5. Once platform frame is finished, modified platform To be covered by 1-1/4″ grating, secured to platform
Utilizing standard grating clips

Copyright © 2021 — Activation WordPress theme by GoDaddy